How it works
How a razor sharpener works
Safety-razor blades went dull after a few shaves, so for half a century inventors raced to bring them back to life. Nearly every piece in this archive works in one of these eight ways. The blade's working edge is shown in red.
01
Pull-handle stropper
Pull the strop back and forth; the blade tips over by itself.
- 1The blade is clamped in a small frame that sits on a leather strop, with a handle at each end of the strop.
- 2You pull the handles back and forth, drawing the leather under the blade.
- 3Each time the strop changes direction, the frame tips the blade over, so the edge always trails and both sides get stropped.
02
Roller stropper
Turn the crank; leather rollers spin against the blade.
- 1The blade sits in a slot inside the case, with its edges against one or more leather (or abrasive) rollers.
- 2Turning the crank spins the rollers, which wipe along the edges in the stropping direction.
- 3Machines are grouped by how many rollers they use, from one to four. Twinplex used two.
03
Rotary stropper
The blade travels round a leather ring and flips over on the way.
- 1The case holds a ring of leather. The blade is carried on an arm inside it, with its edge against the leather.
- 2Turning the handle swings the blade round and round the ring.
- 3Partway round, the mechanism lifts the blade and turns it over so the other side is stropped. Kriss Kross made this famous.
04
Hone-and-strop box (Allegro type)
A carriage runs the blade over a stone one way and leather the other.
- 1Inside the box is a honing stone on one side and a leather strop on the other, with a blade carriage running between them.
- 2Turning the handle drives the carriage from end to end.
- 3Going one way the blade presses on the stone; at the end it flips and comes back along the leather.
05
Pull-cord sharpener (Siemens type)
Hang it on a hook and pull the box along the cord.
- 1Loop the cord over a hook and hold the knob so the cord is tight.
- 2Run the box back and forth along the cord, about fifteen times. The cord turns two little eccentric pins inside.
- 3The blade sits on the pins, so it is swept round in small circles between the grinding stones.
06
Self-stropping razor
Run the whole razor along the strop; the blade never comes out.
- 1The strop is threaded through the head of the razor, with the blade still inside.
- 2You slide the razor up and down the strop, as a barber strops a straight razor.
- 3At each end the blade tips over against the leather, so both edges are stropped. The Valet AutoStrop and the Wilkinson Empire both worked this way.
07
Blade holder
A handle that clamps the blade so you can strop or hone it by hand.
- 1The blade is clamped in a holder with a handle, like a tiny straight razor.
- 2You stroke it along a strop (or a stone, on models that include one), spine first.
- 3Between strokes you turn the holder over to work the other side. Ingersoll’s strop holders worked this way.
08
Hone (stone or glass)
Rub the blade on a fine stone or glass to set a new edge.
- 1The blade, often in a little holder, is rubbed over a fine abrasive: Carborundum stone, or a ridged or frosted glass plate.
- 2A few light strokes grind away the dulled edge and set a new one.
- 3Glass hones were cheap and popular. An old home trick did the same job: rubbing the blade around the inside of a drinking glass.
A few rarer families, such as marble and ball-bearing edgers, magnetic sharpeners, shake-sharps and electric models, will be added here as their workings are documented.
